IBM Options 09N4153 Manuel d'utilisateur

IBM 9.4/4.7 GBDVD-RAM DriveUser’s GuideOPTIONSby IBM

With this MPEG-2 software, you do not need to install an MPEG-2 adapterin your computer to view DVD video files. The software CD contains anMPEG-2 dec

Drive controls and connectorsThe following diagrams show the location and functions of the drive controlsand connectors.Front view of the drive1Disc

Rear view of the drivePin 11Reserved2Audio-out connectorThis connector transmits the analog audio signals to an audio adapter.3Configuration pin

If you must put the drive down, place the antistatic bag on a flat, paddedsurface, such as a magazine, and place the drive on the antistatic bag.Step

Step 4. Mounting the drive in the bayAttention: Be sure to use the M3 x 5-mm mounting screws in the optionpackage when you are driving screws directly

1. Connect the dual-connector end of the included internal audio cable 1tothe audio-out connector on the DVD-ROM drive.2. Attach a 40-pin IDE-cable

1. Insert the InstantWrite SoftwareCD in the CD-ROM or DVD-RAM drive ofyour computer.2. Double-click My Computer.3. Double-click the icon for your CD-

11. Click OK.12. Click OK again.13. Click Close.14. Restart your computer to enable the DMA of your DVD-RAM drive.Step 11. Installing the MPEG-2 Decod

Refer to the documentation that comes with your computer for information onother system-board manufacturers.When you have located the Windows NT 4.0 D

an Intel chipset in your computer. For more information on installingWindows NT Service Packs, visit the Microsoft Web site athttp://www.microsoft.com

Note: Before using this information and the product it supports, read the informationunder Appendix C, ″Product warranties and notices″ on page C-1.Fi

n. During the start process, select the Last Known Good option. If youare unfamiliar with this technique, refer to the documentation thatcomes with yo

protect the media.2. Reverse the procedure to enable writing on the media again.Using single- and double-sided DVD-RAM mediaDVD-RAM media is available

open the disc will eject. Do not touch the recording side of the disc whenhandling the bare media.1-14 IBM 9.4/4.7 GB DVD-RAM Drive: User’s Guide

Returning the disc to the cartridgeTo return the disc to the cartridge, align the label side of disc 1with theDVD-RAM cartridge label side. Insert t

The DVD-RAM drive has two plastic clips near the front of the loading traythat must be lifted up to secure a bare disc for vertical mounting operation

Changing the DVD region codeAttention: Regionalization and Copy Protection (the DVD region code) usesthe content scramble system (CSS) standard to pre

Caring for a CD or DVDDigital discs are high-density media that must be handled with care and keptclean to ensure that they remain readable. The follo

ContentsSafety: Read first ...vPreface ...viiInstallation and user’s guide...1-1Appendix A. Problem

iv IBM 9.4/4.7 GB DVD-RAM Drive: User’s Guide

Safety: Read firstBefore installing this product, read the Safety Information.Antes de instalar este produto, leia as Informações de Segurança.Pred in

Antes de instalar este produto, leia as Informações sobre Segurança.Pred inštaláciou tohto zariadenia si pečítaje Bezpečnostné predpisy.Antes de insta

PrefaceThis manual contains instructions for installing and using the IBM 9.4/4.7 GBDVD-RAM Drive with Software MPEG-2 Option Kit. The manual is divid

viii IBM 9.4/4.7 GB DVD-RAM Drive: User’s Guide

Installation and user’s guideThis section contains the product description, hardware and softwareinstallation instructions, and operating information