IBM DS5020 Manuel d'utilisateur télécharger pdf (Page 159)

3. Determine the bay into which you want to install the E-DDM.

4. Remove the blank tray by doing the following:

a. Release the latch on the E-DDM CRU by pressing on the inside of the

bottom of the tray handle.

b. Lift the closed latch to its open position. (The latch is at a 90° angle to the

front of the E-DDM when open.)

c. Pull the blank tray out of the bay.

d. Save the blank tray for later use.

5. Install the E-DDM by doing the following:

Note: The hard disk drive comes installed in a drive tray. Do not attempt to

detach the drive from the tray.

a. Release the latch on the drive CRU by pressing on the inside of the bottom

of the tray handle.

b. Pull the handle on the tray out so that it is in the open position, as shown in

Figure 80.

Tr ay h a n d l e

Tr ay l a t c h

c. Slide the E-DDM CRU into the empty bay until the hinge of the tray handle

latches beneath the storage subsystem bezel or the adjacent E-DDM CRU

bezel.

Figure 79. Hot-swap E-DDM LEDs

Figure 80. E-DDM CRU handle

Chapter 5. Replacing components 129

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 249 250

Pas de commentaire

IBM DS5020 Manuel d'utilisateur Page 159