IBM Security Camera 343 Manuel d'utilisateur télécharger pdf (Page 45)

4 Configuration Software and Utilities

This chapter describes the Power-On Self-Test (POST) and server configuration utilities. The table

below briefly describes the utilities.

Table 11. Configuration Utilities

Utility Description and brief procedure Page

BIOS Setup If the system does not have a diskette drive, or the drive is

disabled or incorrectly configured, use Setup to enable it.

Or, you can move the CMOS jumper on the server board from the

default setting (Protect CMOS memory) to the Clear setting; this

will allow most server configurations to boot. Then run the SSU to

configure the server.

BIOS Upgrade Utility Use to upgrade the BIOS. 45

System Setup Utility

(SSU)

Use for viewing and clearing the system event log, viewing the

system management FRU information, or viewing the system

management SDR repository.

FRUSDR Load Utility Use to update the Field Replacement Unit (FRU), Sensor Data

Record (SDR), and SM BIOS (SMB) flash components.

Firmware Update Utility Use to update the Firmware. 56

Using the Adaptec SCSI

Utility

Use to configure or view the settings of the SCSI host adapter and

onboard SCSI devices in the server.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 186 187

Pas de commentaire

IBM Security Camera 343 Manuel d'utilisateur Page 45