Ibm L180p Manuel d'utilisateur télécharger pdf (Page 11)

ENGLISH

Connecting your monitor

1. Turn off your computer and all attached devices. Next, unplug all power

cords to your computer and all attached devices.

2. Connect the signal cable.

• The analog signal cable is already connected to your monitor

(See in Figure A).

• When connecting the analog signal cable, connect the free end of the

attached signal cable to the 15-pin monitor port on the computer and

tighten screws.

• If you are connecting a DVI-D digital signal cable, follow Figure B.

Connect one end of the monitor signal cable to the white connector

on the rear panel of the monitor. Connect the other end to the white

connector on the rear panel of the computer and tighten the screws.

Figure B

Figure A

Be sure to read the Safety

Information located in the

Monitor Safety and Warranty

Information Manual before

carrying out this procedure.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 32 33

Pas de commentaire

Ibm L180p Manuel d'utilisateur Page 11