Ibm SG24-4576-00 Manuel d'utilisateur Page 148

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 235
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 147
4.5 Installing NetWare 4.1 with the Original CD-ROM
In this section, we detail the procedures necessary to install NetWare 4.1 using
the original product CD-ROM.
4.5.1 Hardware Requirements
The following hardware is required to install NetWare 4.1:
One file server with an Intel 386 processor or higher
A minimum of 8 MB of RAM
A minimum of 20 MB in a DOS disk partition
At least one network adapter card
A CD-ROM drive
4.5.2 Software Requirements
The following software is required to install NetWare 4.1:
NetWare 4.1 CD
DOS 3.3 or later
Drivers for the adapter cards
4.5.3 Installation Procedure
1. Install DOS in the primary partition.
A minimum of 20 MB of hard disk is required; this is because during the
installation, boot files are copied to this partition.
2. Install the drivers for CD-ROM access. See Appendix C, “Configuring DOS
CD-ROM Support” on page 203 for more information on configuring the
system for CD-ROM support.
During this process the CONFIG.SYS and AUTOEXEC.BAT files are modified
and a drive letter is assigned to the CD-ROM drive.
3. Reboot the server.
4. Insert the NetWare 4.1 CD into the CD-ROM drive.
5. Change to the CD-ROM drive.
6. Type
Install and press Enter.
The installation menu appears as shown in Figure 91 on page 136.
Chapter 4. Novell NetWare Installation 135
Vue de la page 147
1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 234 235

Commentaires sur ces manuels

Pas de commentaire